Metro-North’s mangled and much-maligned service in Connecticut is made all the more challenging by a technological quirk of fate. Ours is the only commuter railroad in the US that operates on three modes of power… AC, DC and diesel.
On a typical run from, say, New Haven to Grand Central, the first part of the journey is done “under the wire”, the trains being powered by 13,000 volt AC overhead wires, or catenaries. Around Pelham, in Westchester County, the conversion is made to 660 volt DC third rail power for the rest of the trip into New York. Even diesel trains must convert to third-rail as their smoky exhaust is banned in the Park Avenue tunnels.
And there’s the rub: Connecticut trains need both AC and DC, overhead and third-rail, power pick-ups and processors. That means a lot more electronics, and added cost, for each car. While the DC-only new M7 cars running in Westchester cost about $2 million each, the proposed dual-mode M8 car designed for Connecticut could cost $3.5 million each.
So, some folks are asking… “Why not just use one power source? Just replace the overhead wires with third-rail and we can buy cheaper cars.” Simple, yes. Smart, no. And here’s why.
Ø There’s not enough space to lay a third-rail along each of the four sets of tracks in the existing right of way. All four existing tracks would have to be ripped out and the space between them widened. Every bridge and tunnel would have to be widened, platforms moved and land acquired. Cost? Probably hundreds of millions of dollars, years of construction and service disruptions.
Ø Even with third-rail the CDOT would still be required to provide overhead power lines for Amtrak. That would mean maintaining two power systems at double the cost. We’re currently spending billions just to upgrade the eighty-year old catenary, so why then replace it?
Ø Third-rail AC power requires substations every few miles, meaning further construction and real estate. The environmental lawsuits alone would kill this idea.
Ø DC driven third rail is less efficient. Trains accelerate much faster using overhead AC voltage, the power source used by the fastest trains in the world… the TGV, Shinkansen, etc. On third-rail speeds, are limited to 75 miles an hour vs. 90 mph under the wire. That means, mile for mile, commute time is longer using third rail.
Ø Third rail ices-up in bad weather and can get buried in snow causing short circuits. Overhead wires have problems sometimes, but they are never buried in a blizzard.
Ø Third-rail is dangerous to pedestrians and track workers.
The idea of conversion to third-rail was studied in the 1980’s by consultants to CDOT. They concluded that, while cumbersome and costly, the current dual-power system is, in the long run, cheaper and more efficient than installing third-rail. This time, the engineers at CDOT got it right.
Not satisfied, some of the third-rail fans are now pushing bills through the Legislature to study the replacement scheme yet again. More studies would mean years of delay in ordering already overdue car replacements.
I trust the Legislature will dispense with these nuisance proposals quickly and get on with the task at hand… ordering new cars now. Even if the needed funds are appropriated today and the order placed immediately, new cars won’t be delivered for five or six years. Further studies of third-rail vs. overhead catenary only make us wait longer.
JIM CAMERON has been a Darien resident for 13 years. He is Vice Chairman of the CT Metro-North / Shore Line East Rail Commuter Council, and a member of the Coastal Corridor TIA and the Darien RTM. You can reach him at jim@camcomm.com or www.trainweb.org/ct
Commentary on transportation in Connecticut and the Northeast by JIM CAMERON, for 19 years a member of the CT Rail Commuter Council. Jim is also the founder of a new advocacy effort: www.CommuterActionGroup.org Disclaimer: his comments are only his own. All contents of this blog are (c) Cameron Communications Inc
Subscribe to:
Post Comments (Atom)
WASTING OTHER PEOPLES' MONEY
When we are spending our own hard-earned money, we are usually pretty cautious, especially in these tough times. But when it comes to spend...
-
Some people say I’m a curmudgeon with never a nice thing to say about Metro-North or the CDOT… always complaining… too negative. Well, t...
-
I love AI (artificial intelligence). I rely on it daily to help with my research. “How many bar cars did Metro-North operate in the 199...
-
Ready for a summer vacation? Car packed, airline tickets at hand? You may not realize it, but Big Brother’s coming along with you. Howeve...
2 comments:
I just have a technical question, What would stop anybody from being able to power two tracks from one third rail? Too much electricity needed?
The only things stopping that would be physics.
Two trains, in the same or opposite directions, cannot share the same 3rd rail... because their pick-up shoes would collide.
Post a Comment